Only the standart Beaver goes right with the GTN750

Chuck Jodry
Posts: 442
Joined: Mon Dec 20, 2010 4:30 pm
Re: Only the standart Beaver goes right with the GTN750

Post by Chuck Jodry » Sat Feb 15, 2020 4:24 pm

From my read you boys found a typo or dir error in the single 750 config somewhere and used the dual 7/650 solves it apparently and that narrows down the possible culprit , the popup thing cant say , what can be said , Ill look into it next week and report back , the Beaver is in need of some love during Valentines .

Best CJ

LZScout
Posts: 7
Joined: Thu Jan 30, 2020 2:10 pm
Re: Only the standart Beaver goes right with the GTN750

Post by LZScout » Sat Feb 15, 2020 6:40 pm

Yes Chuck, to be specific for my situation, if I use Shift 3 to bring up the 2d panel of the GTN 750, it either comes up blank or will freeze at some point during the flight. The panel mounted unit always works, goes blank (as it should) when the 2d window is open, then displays again when the 2d window freezes. I’ve tried undocking the 2d window and moving it to a different monitor but the behavior remains the same.


Locked

Return to “DHC-2 Beaver Support Forum”