Start Up and MVAMS2
-
SloppyDog
- Posts: 4
- Joined: Wed Apr 03, 2019 12:05 am
- Contact:
Start Up and MVAMS2
Hello all,
I recently bought the A-1H Skyraider. I installed it, following the instructions: no anti-virus, running as an Administrator, etc.
But I cannot seem to make a proper start up, as per the manual. I turn on the fuel boot pump, and the fuel pressure moves just a bit, but does not get nowhere near the required (per manual) 16 PSI pressure. Turn on the magnetos to both, mixture off, I press primer, and the starter. The engine starts turning but does not catch. I've tried and tried this, and the only way it catches is by using the Crtl+E P3D shortcut. After that, everything is ok.
Also, the MVAMS2 program does not open. I click on it, or use the right click menu to run it as an administrator, but in each case the software does not open. I don't know if I need it to make the A-1 work properly.
I recently bought the A-1H Skyraider. I installed it, following the instructions: no anti-virus, running as an Administrator, etc.
But I cannot seem to make a proper start up, as per the manual. I turn on the fuel boot pump, and the fuel pressure moves just a bit, but does not get nowhere near the required (per manual) 16 PSI pressure. Turn on the magnetos to both, mixture off, I press primer, and the starter. The engine starts turning but does not catch. I've tried and tried this, and the only way it catches is by using the Crtl+E P3D shortcut. After that, everything is ok.
Also, the MVAMS2 program does not open. I click on it, or use the right click menu to run it as an administrator, but in each case the software does not open. I don't know if I need it to make the A-1 work properly.
-
Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Start Up and MVAMS2
I believe there is an MVAMS2 installer in the aircraft redistributables folder. Try running that again or reinstall the whole aircraft. Are you sure you have exclusion in defender for your P3D folder?