MV 407 Support Forum

[Krazycolin]

Hi and welcome to the MV 407 support forum.

Any and all questions concerning the flight, operation and problems are allowed and welcome here.

However, do note that we reserve the right to refuse to fix certain issues. (no idea what those may be but... we reserve the right)

Thanks

[werderbam]

ok lets start.this is my first visit to this forum.thanks to steve and collin to get an account.so here my problem with the 407.after the startup procedure at point 11 called
press and hold start switch no rpm indicator no spinning rotor.only hear the engine but nothing happen and the engine started again and again.so i tell you what ive done to run the tips ive got.deactivated the weather.no result.deactivated the antivir to download.try to start with ctrl+e, impossible.move the 407 to 180 degrees cause the wind no result.ive win 7 64bit and a very fast pc.what can ido ?

the best
frank

[Chuck Jodry]

Sounds like the fuel switch is off .

Best CJ

[werderbam]

thanks for help but the fuel valve is on.is there eventualy another startup procedure.

[Chuck Jodry]

Did you set the ACM for cold and dark startup and load the 407 or did you load a saved flight with another aircraft and then switch to the 407 ?

Try loading the 407 from the selection menu if you used a saved flight .

Thanks CJ

[werderbam]

it doesnt work both.its always the same.after startup processed all only hear the engine.the mgt goes to 814 than back to zero and hear the engine start again.

frank

[Chuck Jodry]

Hello Frank , the start switch has a release function as well , the switch needs to be centered after use , click , hold, release or the inertial starter keeps going .

Question , the fuel booster switches are on ?
We will get you started yet !

[JonathanBleeker]

Try pressing Ctrl F4 for full mixture as well.

[werderbam]

hello helpers,
followed all advises but unhelpful.the problem is still there.

thanks
frank

[JonathanBleeker]

Sorry not Ctrl F4 but Ctrl Shift F4.

[Krazycolin]

turn on the fuel pump

turn on the fuel boosters

turn on the battery

turn on the hydraulics

click the start switch TWICE

watch your N1.

once it gets as far as it seems to go, try clicking on the throttle (cyclic) and rotate that until it says FLY.

[werderbam]

hello,
idont know what happen but i think ive solved the problem.load the cessna 172 put the white tank selector to both (normal is on left)and save the flight to standard.then load the helicopter and it works.

thanks so much
frank

[werderbam]

hello,
once more to the startup problem.i think ist very important to get a good standard flight so the cessna 172.weather was not the problem.the next problem is kaspersky regognize the acm as a virus.its not so bad but akward. want to use the acm i must new install complete with the helicopter.so i save the hole file particularly the aircraft cfg.deactivated kaspersky and install new.open the acm and set all types to cold and dark.after activated kaspersky acm is a trojan again but it doesnt matter.you have saved the variants before.but if you install a new repaint you must start the hole procedure again.hope i can help others so.

good flights
frank

[N4GIX]

Configure your kapersky anti-virus to exclude the ACM entirely. Problem solved.

[werderbam]

thank you bill it works

the best
frank