Page 1 of 1
Problem with throttle calibration
Posted: Tue Feb 18, 2020 5:48 pm
by real
Hi,
When calibrating throttle, prop and condition levers should i see a blue line moving when i move a lever. I say that because i saw a sceenshot here in this forum showing a blue line in the "max reverse/beta/idel/max power box. Even though i try to calibrate, levers are always moving (mostly throttle ones) when flying. Could somebody help me with this. Thanks a lot
Real
Re: Problem with throttle calibration
Posted: Tue Feb 18, 2020 9:47 pm
by Raptor
Yes, When you select the right lever for the axis you are calibrating you will see a gray bar moving as you move your lever
Re: Problem with throttle calibration
Posted: Tue Feb 18, 2020 10:54 pm
by real
Hum. In that case i have a problem with it. Thanks
Re: Problem with throttle calibration
Posted: Tue Feb 18, 2020 11:05 pm
by real
Any idea why i don't see this bar moving
?
Re: Problem with throttle calibration
Posted: Tue Feb 18, 2020 11:22 pm
by Raptor
Apologies if I am uber dumbing this down... Want to explain it best I can...
1. If you are using FSUIPC, you have to set your lever there. MVAMS is only a calibration tool, not used to assign axis.
2. MVAMS is a 3 step process.
a) Select what you want to control (Power Lever 1 in my picture below)
b) Select the device you will use to control that. If you have the Saitek Yoke, the 3 levers that come with the yoke will be under Saitek Yoke
c) Select the axis you will use for that control. You may need to select each one to see which is moving
3. Make sure you save after each control is set
Re: Problem with throttle calibration
Posted: Tue Feb 18, 2020 11:23 pm
by Raptor
more pictures
Re: Problem with throttle calibration
Posted: Wed Feb 19, 2020 1:10 am
by real
Thank you very much Sergio. I'll give a try tomorrow.
Real
Re: Problem with throttle calibration
Posted: Thu Feb 20, 2020 8:45 pm
by real
They work better now but i think that's because my throttle quadrant is getting old. Levers always moving a bit. Thanks again.