Latest installer : MilViz T-38A ADV SP3.2 v3.171224

[doodlebug]

MilViz T-38A ADV SP3.2 v3.171224

Changelog:

Trim inputs now possible via POV hat

[N1RB]

Is this update also for FSX boxed.
Thanks
N1RB

[doodlebug]

This is multi-platform with the same specs as the previous installer. If hat trim is not an issue for you, you may decide to stick with what you've got.

[Alvaro]

This is multi-platform with the same specs as the previous installer. If hat trim is not an issue for you, you may decide to stick with what you've got.

Hey Osh,

Just a small comment:
There're several minor fixes in this latest version so, every user should update to this.

Álvaro

[N1RB]

Downloaded latest update for the T38 ADV Ver3.171224 and installed it into FSX. Antivirus was off for the download and installation. My problem is it will not start.With all the proper switches on using the power cart or the ground unit when the start button is pushed it makes a clicking sound for about 30 sec. then nothing. Previous Ver. started great, any help would be greatly appreciated.
Thank you
N1RB

[Alvaro]

Downloaded latest update for the T38 ADV Ver3.171224 and installed it into FSX. Antivirus was off for the download and installation. My problem is it will not start.With all the proper switches on using the power cart or the ground unit when the start button is pushed it makes a clicking sound for about 30 sec. then nothing. Previous Ver. started great, any help would be greatly appreciated.
Thank you
N1RB

- Check fuel cells are not at 0%

- Check engine switch setup is correct (battery on, master on, pumps on, etc...)

- Check the starting engine throttle is at idle or slightly higher setting. Fuel Flow reading should be around 400 pph before lightoff.

- Try reloading aircraft (and check fuel>0%). If this is the case, save a new flight as new versions use to break old saved flights.

Anyway, there´re no changes affecting engines start-up in this new version.

(Edit: I´ve just performed cold&dark startups with both, power cart and ground unit without any issue)

[N1RB]

After several re-installs of Ver. 3.171224 I could not resolve the start problem so I reinstalled Ver. 3.170726 which runs great. I thought on an upgrade of an original aircraft it did not count as a download. I went from 3 to 0 Can I get more downloads if there are more updates?
Thank you for your time
N1RB

[doodlebug]

Downloads are automatically reset with an update. I will reset yours now just to be on the safe side.