Blackbird Sims / Milviz Forum Archive

1. When tuning in 051X at ETSI I can only see the DME. The bearing is stuck on South.
2. Switching between X and Y always resets the selection back to the last inserted. Sometimes it also resets it to the last freq, like from 52 to 28.

I tried to install the C++ 2015 Redistributable, but the installation fails as C++ 2017 is also installed?
I can't see any 2015 version in Add or remove Programms in the Windows 10 settings.

AV isn't scanning my sim dir and was turned off during installation (Win Defender).
Installation was made with Admin rights.

Any ideas?

2017 is ok. I am on my phone at the moment so can’t answer on the other issues.

Thanks Jonathan.

The "none bearing" issue can be closed
I have to manually change the DME TACANs to VOR/DME, to make it work.
So basically just the freq jumping issue remains.