Can not prime engines manually

Locked
ghostrider78
Posts: 6
Joined: Sat Oct 03, 2015 2:29 pm
Can not prime engines manually

Post by ghostrider78 » Tue Jan 31, 2017 12:55 am

I am running boxed version of FSX with service pack 1 and acceleration; also running Windows 10. If I manually prime the engines, the red fuel pressure light never goes out and engines will not start. If I use the electric fuel pumps, red pressure light goes out and engines start up just fine. Any thoughts as to why I can not prime engines manually?
Thank You !
ghostrider78
Top
N4GIX
Posts: 1023
Joined: Mon Sep 06, 2010 3:47 pm
Re: Can not prime engines manually

Post by N4GIX » Tue Jan 31, 2017 7:35 pm

Use the wobble pump to boost the fuel pressure. Look between the two front seats. Operate the lever six to ten strokes until the lights extinguish.
Top
Kat
Posts: 94
Joined: Mon Feb 08, 2016 7:30 pm
Re: Can not prime engines manually

Post by Kat » Tue Jan 31, 2017 8:31 pm

Have a look at this
T-50 Bobcat authentic full start procedure
Top
ghostrider78
Posts: 6
Joined: Sat Oct 03, 2015 2:29 pm
Re: Can not prime engines manually

Post by ghostrider78 » Wed Feb 01, 2017 1:43 am

Thank you gentlemen, I feel like an idiot .... never saw the wobble pump. That was my mistake,
ghostrider78
Top
Locked

Return to “Bobcat Support Forum”