WX Radar Wont Turn On

[flyalaska]

here is what I see on the pop up.

[JonathanBleeker]

Thanks. There was some confusion going on.

Unzip this into the main panel folder of the DHC-2 Beaver Milviz folder and lets see if that resolves it:

https://www.dropbox.com/s/cn4lql8eyeheh ... 4.zip?dl=0

[flyalaska]

It did not

[JonathanBleeker]

Does it work if you fly one of the beaver variants that isn't in the Spray'n'Play package?

[flyalaska]

Doesn't work on any version, Doesn't work on the Otter either.

[JonathanBleeker]

Ok please start your sim, and go to options->General->Application and enable Content Error Reporting. Load the beaver or Otter, then close the sim. Go to your documents\Prepar3D v4 Files and zip the ContentErrors.txt and post. Not sure why I didn't think of this sooner.

[flyalaska]

Here you go.

[JonathanBleeker]

Sorry for the delay in response.

I found the following error message:

C-style gauge failed to load: E:\SimObjects\Airplanes\DHC-2 Beaver Milviz\panel.GNS750_WX\..\panel\MV_WX.dll, Gauge: WX. DLL is 32 bit. A 64 bit version is required.

Go to the E:\SimObjects\Airplanes\DHC-2 Beaver Milviz\panel and delete the MV_WX.dll. Then replace it with this one.

https://www.dropbox.com/s/cn4lql8eyeheh ... 4.zip?dl=0

[flyalaska]

That did it. Radar works on all my variants. Will this work on the Otter too?

[JonathanBleeker]

Yes.

[flyalaska]

Thank you for all your help!

[Krazycolin]

I’d like to know how the 32bit version ended up there.

[JonathanBleeker]

https://www.dropbox.com/s/j5j87kmm6861u ... 4.zip?dl=0

Updated link