Failure of propeller to feather and stop turning.[Answered]

[apmech]

While in flight, I shut down the right engine but the propeller keeps turning. The throttle all the back, mags off, mixture idle cut-off, prop pulled all the way back past the detent and the propeller is still turning. In the feathered position the prop stops rotating but it does not. I'm I missing something?
Thanks, Pat.

P.S. I'm getting a good workout in single-engine out procedures in your twin, which are aerodynamically correct, except the prop does not stop turning.

[Slayer]

Hi Pat.

Just to be sure, are you doing what it says on page 24 of the user guide? ( located in the aircraft/manuals folder)

feather.JPG (197.68 KiB) Viewed 983 times

Are you using hardware to control the prop levers?

I am not able to duplicate what you are seeing, the props stop here on my end.

[apmech]

Thank you for your quick response.

Although I read the manual, I forgot to recheck that area.
All my controls and gauges are Logitech (Satitek).

It is cumbersome to use the mouse rather than just simply move the prop control fully aft; but the mouse works to feather the prop as per the manual.

Thanks again, Pat.