Throttle is stuck - in reverse - no movement [Resolved]
-
- Posts: 2
- Joined: Fri Oct 16, 2020 3:58 pm
Throttle is stuck - in reverse - no movement [Resolved]
Bought through and installed by Orbyx
P3D V4.5
no problems with any thing else so far OG because I cant get the A/c started
The Throttle lever is stuck in the reverse position and I cant get any movement of it
therefore I cannot start up
it will not move - either with the control binding (saitek) or with the mouse
I have checked the tighten button to full free
The prop and mixture controls all work as all bound buttons and Axes
P3D V4.5
no problems with any thing else so far OG because I cant get the A/c started
The Throttle lever is stuck in the reverse position and I cant get any movement of it
therefore I cannot start up
it will not move - either with the control binding (saitek) or with the mouse
I have checked the tighten button to full free
The prop and mixture controls all work as all bound buttons and Axes
- Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Throttle is stuck - in reverse - no movement
It sounds like XMLTools is not installed. Have you contacted ORBX support yet? There should have been an updated installer from them to address this.
-
- Posts: 2
- Joined: Fri Oct 16, 2020 3:58 pm
Re: Throttle is stuck - in reverse - no movement
Thanks a mill for that - it was the problem
Nick Cooper gave me a small insert that I installed and it worked
now all I have to do is stop the mixture jumping in the binding