Throttle is stuck - in reverse - no movement [Resolved]

Locked
jaytee
Posts: 2
Joined: Fri Oct 16, 2020 3:58 pm
Throttle is stuck - in reverse - no movement [Resolved]

Post by jaytee » Sat Oct 24, 2020 11:42 am

Bought through and installed by Orbyx
P3D V4.5
no problems with any thing else so far OG because I cant get the A/c started
The Throttle lever is stuck in the reverse position and I cant get any movement of it
therefore I cannot start up
it will not move - either with the control binding (saitek) or with the mouse
I have checked the tighten button to full free
The prop and mixture controls all work as all bound buttons and Axes

User avatar
Slayer
Posts: 1517
Joined: Sat Mar 08, 2014 3:26 am
Contact:
Re: Throttle is stuck - in reverse - no movement

Post by Slayer » Sun Oct 25, 2020 10:33 am

It sounds like XMLTools is not installed. Have you contacted ORBX support yet? There should have been an updated installer from them to address this.

jaytee
Posts: 2
Joined: Fri Oct 16, 2020 3:58 pm
Re: Throttle is stuck - in reverse - no movement

Post by jaytee » Fri Oct 30, 2020 1:24 pm

Slayer wrote:
Sun Oct 25, 2020 10:33 am
It sounds like XMLTools is not installed. Have you contacted ORBX support yet? There should have been an updated installer from them to address this.
Thanks a mill for that - it was the problem
Nick Cooper gave me a small insert that I installed and it worked
now all I have to do is stop the mixture jumping in the binding :roll: :roll:


Locked

Return to “DHC-3T Turbo Otter Support Forum”