Wrong QNH
-
- Posts: 10
- Joined: Tue Jun 21, 2016 3:32 pm
Wrong QNH
Hello to you.
I am using the B407 with fun. However I am strugglin with the QNH. That means the B407 is giving the wrong QNH. When I change it with e.g. the Cessna 182 of A2A, the read out of the QNH is oke.
As an example, I am at NZQN airport.
Correct: At the moment the local QNH is 1011 millibar / 29.86 inches of mercury. The airport elevation is 1170FT
Wrong: 1021Mb / 3030. In this case the reading on the B407 altimeter.
Can anyone tell me what might going wrong please. How to solve?
I am using P3D v3.3
Thanks and regards,
Ed
I am using the B407 with fun. However I am strugglin with the QNH. That means the B407 is giving the wrong QNH. When I change it with e.g. the Cessna 182 of A2A, the read out of the QNH is oke.
As an example, I am at NZQN airport.
Correct: At the moment the local QNH is 1011 millibar / 29.86 inches of mercury. The airport elevation is 1170FT
Wrong: 1021Mb / 3030. In this case the reading on the B407 altimeter.
Can anyone tell me what might going wrong please. How to solve?
I am using P3D v3.3
Thanks and regards,
Ed
-
- Posts: 5
- Joined: Thu Aug 06, 2015 1:11 pm
Re: Wrong QNH
Hi,
The same is with me, I have posted this problem earlier in this forum but got a reply from the devs that it is OK.
When you set the actual QNH you have to read the airport ELEV (AMSL) on the altimeter - which is simply not the case with Milviz.
Cheers,
tamas
The same is with me, I have posted this problem earlier in this forum but got a reply from the devs that it is OK.
When you set the actual QNH you have to read the airport ELEV (AMSL) on the altimeter - which is simply not the case with Milviz.
Cheers,
tamas
-
- Posts: 10
- Joined: Tue Jun 21, 2016 3:32 pm
Re: Wrong QNH
Hi Tamas,
If I am not the only one, there musr be something wrong indeed. So I hope any of the technicians will have a look again and please reply to this.
Thanks and regards,
Ed
If I am not the only one, there musr be something wrong indeed. So I hope any of the technicians will have a look again and please reply to this.
Thanks and regards,
Ed
-
- Posts: 442
- Joined: Mon Dec 20, 2010 4:30 pm
Re: Wrong QNH
Hello , testing this its seen to be in error , an overhaul is due to update the WX and GNS units and I will put this in the list to be fixed at the same time .
Thanks for bringing it to our attention.
Best CJ
Thanks for bringing it to our attention.
Best CJ