Cannot set afterburner threshold
-
- Posts: 21
- Joined: Thu Jan 30, 2020 2:59 am
Cannot set afterburner threshold
When I go into MVAMS to modify the afterburner threshold, the program doesn't seem to detect my throttle axes at all. I move my throttle levers throughout their full range of motion, and I never see a slider. And when I click to set, it just defaults to having the red line all the way to the left.
The throttles control thrust when actually flying the module just fine, and I never had this issue in P3D v4. Any ideas? My controllers are set to Direct Input, and when I select the dropdown menu option while in the sim to set afterburner threshold, it crashes P3D outright.
The throttles control thrust when actually flying the module just fine, and I never had this issue in P3D v4. Any ideas? My controllers are set to Direct Input, and when I select the dropdown menu option while in the sim to set afterburner threshold, it crashes P3D outright.
- Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Cannot set afterburner threshold
Thanks for the feedback, I've forwarded this to the dev team.
-
- Posts: 3446
- Joined: Sat Mar 13, 2010 7:38 pm
Re: Cannot set afterburner threshold
Verify that you are running both P3D and the MVAMS as admin, otherwise the MVAMS will look in the wrong user account for P3D control config.
-
- Posts: 21
- Joined: Thu Jan 30, 2020 2:59 am
Re: Cannot set afterburner threshold
Just tried both. Running MVAMS as administrator has no effect and the slider still does not move. Running P3D as administrator, opening a scenario flying the T-38, and attempting the dropdown menu option still freezes and crashes the sim.JonathanBleeker wrote: ↑Sat Aug 01, 2020 6:07 pmVerify that you are running both P3D and the MVAMS as admin, otherwise the MVAMS will look in the wrong user account for P3D control config.
-
- Posts: 10
- Joined: Sun Mar 19, 2017 6:48 pm
Re: Cannot set afterburner threshold
Same problem. Just verified that P3DV5 and MVAMS are both running as admin. In the MVAMS it ignores any input when attempting to set. When in sim, and using drop down menu to pick set afterburners, system CTD's and P3DV5 terminates.
I'm sure that it will get fixed...and Thank you very much for the free upgrade! Looking forward to getting the rest of my Milviz fleet back in to the air.
Dean
I'm sure that it will get fixed...and Thank you very much for the free upgrade! Looking forward to getting the rest of my Milviz fleet back in to the air.
Dean
-
- Posts: 3446
- Joined: Sat Mar 13, 2010 7:38 pm
Re: Cannot set afterburner threshold
Oh I see what's happening. My bad. I forgot to update the MVAMS module to support P3D v5