Visually incorrect...
-
- Posts: 74
- Joined: Sun May 28, 2017 7:54 pm
Visually incorrect...
Hello Milviz,
I was wondering when you will fix the FDE on the Porter!? The nose appears to be to high in the air when flying flat and level. Also the elevator is ALWAYS in the nose down position even when trimmed for flat and level flight!!! It should be flat or the same chord line as the horizontal stabiliser as per ALL real life Porters when flying.
I was wondering when you will fix the FDE on the Porter!? The nose appears to be to high in the air when flying flat and level. Also the elevator is ALWAYS in the nose down position even when trimmed for flat and level flight!!! It should be flat or the same chord line as the horizontal stabiliser as per ALL real life Porters when flying.
-
- Posts: 74
- Joined: Sun May 28, 2017 7:54 pm
Re: Visually incorrect...
Well over 12 months and no reply!!!
Great customer service!
Great customer service!
- Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Visually incorrect...
Sorry, your post was long before I took over in forum support. I will forward this to the devs. If/when there is an update I will ask if it can be checked.
-
- Posts: 74
- Joined: Sun May 28, 2017 7:54 pm
Re: Visually incorrect...
Any word from the Dev's on this one?
- Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Visually incorrect...
PC-6 Development is done on P3D. It is in the process of being developed for MSFS now. Sorry.
-
- Posts: 74
- Joined: Sun May 28, 2017 7:54 pm
Re: Visually incorrect...
I am sorry too. Will never purchase another Milviz product again.
I wish all the best.
I wish all the best.